5/1/2023 0 Comments Mach3 serial port arduino![]() ![]() I dug up all the information I could find on my particular TB6560 controller board, including schematic and documentation, but being as how these are mass produced in China with several minor changes between each clone, the documentation was both helpful and misleading at times. It accepts GCODE from the computer, and Grbl translates this into pulses, used by stepper controllers, pushing around stepper motors, while providing feedback when any limit or control switches are hit. The basics of the project are, Arduino has a USB interface, which acts like a serial port. Being as USB was the ideal interface, and from previous searching around, seems like a great solution. ![]() ![]() The board has plenty of power to push the steppers around, far more than any of the smaller / cheaper solutions had to offer I think, so I wanted to try and teach this board a few new tricks, and let me interface with it using a more modern interface. For those unfamiliar, boards like this are interfaced using an old fashioned LPT parallel port, which was initially an annoyance, but quickly became impractical and a hassle, having to use an old PC with VNC installed. I’ve had a CNC mill for a few years now, and while many homemade CNC mills use EasyDriver or Pololu, mine came with a sturdy, generic TB6560 controller board. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |